When replacing the TCM, please reference the following link:
CLICK ON GT-R Tab
You need a Consult 3 + GT-R Card and this software to code the TCM to the Transmission.
You need the SERIAL NUMBER off the transmission.
GT-R ONLY SOFTWARE
Please Note: GT-R software can only be installed on a Nissan Panasonic Toughbook computer.
C-III plus GT-R software supports 2009~2014 MY North American market GT-Rs.
CONSULT III plus GT-R Diagnostic Software (version 20.11.00)
To install GT-R diagnostic software version 20.11.00, you must have an operating version (26.12.00 or higher) of the standard CONSULT III plus diagnostic software. GT-R software is a plug-in addition to the base software.
To access GT-R diagnostic software, you will need a special “Nissan GT-R diagnosis& repair IC card and adapter”. This card and adapter can be purchased by calling Bosch at 1-800-662-20011-800-662-2001 and asking for part number J47446-GTR-AM.
GT-R TRANSMISSION CONFIGURATION USING THE CONSULT III plus
When the transmission or transmission control unit is replaced, the IP characteristic data must be written into the TCM. This process is called TCM configuration. If the data is not written into the replacement TCM, the transmission will not operate correctly. When the transmission is replaced, the characteristic data for the new transmission must be written into the TCM. This application requires the use of the Nissan CONSULT III plus diagnostic software version 6.12 or above, and GT-R diagnostic software version 14.12 or above, and the GT-R diagnostic security card.
To perform TCM configuration you will need to download the “TCM configuration application” and the “TCM configuration database.
Download C-III plus TCM Config. Software (Version 2013/03/01 rev 3) .....no charge
Install the software by running “TCM_CONFIG_SETUP_FOR_C3Plus.EXE"
Download C-III plus TCM Configuration Database.....no charge
Database is updated daily so please be sure to download the latest data before trying to configure the TCM.
After downloading the database, EXTRACT the database to folder C:\CONSULT-III_plus\System\Application\ApplicationData\ATWS. From the desktop, launch the application and enter the transmission serial number into the application and select “Read and Search”. The application will automatically place the correct IP config data in the proper C-III plus location. Use “TCM Work Support” in C-III plus to write the data to the TCM.